Jagdtiger No.41 in Germany

Forum for discussion relating to the Jagdtiger
User avatar
Marco Peter
Posts: 368
Joined: Mon Feb 26, 2018 12:05 pm
Has liked: 436 times
Been liked: 425 times

Re: Jagdtiger No.41 in Germany

Post by Marco Peter »

I'll PM you! :-)
'Konan', my Tiger 1 Mid
'Gunther', my Panther G

User avatar
Sascha Hornbach
Posts: 21
Joined: Wed Mar 17, 2021 10:31 am
Location: Schifferstadt
Has liked: 39 times
Been liked: 60 times

Re: Jagdtiger No.41 in Germany

Post by Sascha Hornbach »

Hello,

I mill some lifting hooks for front and motordeck. There are 3 sizes and a few differences between JT and KT. I also made the Prototype of the MG base on the motor hatch.
JT_030.jpg
JT_031.jpg
JT_032.jpg
The air intakes are also new because the kit intakes are too small.
JT_033.jpg
JT_034.jpg
best regards

Sascha
Maximus Caprorum

User avatar
Sascha Hornbach
Posts: 21
Joined: Wed Mar 17, 2021 10:31 am
Location: Schifferstadt
Has liked: 39 times
Been liked: 60 times

Re: Jagdtiger No.41 in Germany

Post by Sascha Hornbach »

Small update today:

I made the decision to change the hub caps. First I think about to make in in Aluminum, but the result in resin is nice.
JT_036.jpg
JT_035.jpg
JT_038.jpg
Next thing was the NOTEK Kolonnenlicht, I also printed it in 3D. There are 2 parts to illuminate it with SMD LED.
JT_037.jpg
best regards

Sascha
Maximus Caprorum

User avatar
Sascha Hornbach
Posts: 21
Joined: Wed Mar 17, 2021 10:31 am
Location: Schifferstadt
Has liked: 39 times
Been liked: 60 times

Re: Jagdtiger No.41 in Germany

Post by Sascha Hornbach »

Next thing was the frontplate with the inlay for the hatches. At the real Jagdtiger/KT the inner plate is bolted from the inside. At the hull there are only very flat holes or small circles. First I closed The holes with aluminium plugs in 6mm and 3mm. Next step was to shape them for a flat surface. At least I had to drill new holes and made the threads.

best regards

Sascha

JT_039.jpg
JT_040.jpg
JT_041.jpg
Maximus Caprorum

Post Reply