Benedini Mini and MG flash

Forum for Armortek Owners to Meet, chat and share knowledge. You are advised to check 'official advice' before carrying out any modifications.
Post Reply
User avatar
Steen Vøler
Posts: 766
Joined: Mon Nov 19, 2012 2:45 pm
Location: Denmark
Has liked: 62 times
Been liked: 493 times

Benedini Mini and MG flash

Post by Steen Vøler »

hi all

Anybody by chance have a picture of how to wire connect the MG flash cables to a Benedini Mini.

there are 2 wires Plus & Minus to the MG LED - how does these 2 connect to the output 1+2 on the benedini mini

Would it be Minus at the buttom and the Plus on top leaving the middle pin free or?
cheers
Steen

www.panzerteam.dk

User avatar
Adrian Harris
Posts: 4820
Joined: Thu Jul 12, 2007 10:46 pm
Location: Berkshire (UK)
Has liked: 1137 times
Been liked: 1298 times

Re: Benedini Mini and MG flash

Post by Adrian Harris »

http://benedini.de/TBSMini_13_E.pdf

If it has been configured, it should be between the middle and top pins of "OUT 1+2",with the middle going to the anode (+ve) and the top going to the cathode (-ve).

Middle and bottom of "OUT 1+2" should be the trigger signal for the main gun recoil.

Adrian.
Contact me at sales@armortekaddict.uk for details of my smoker fan control module

User avatar
Steen Vøler
Posts: 766
Joined: Mon Nov 19, 2012 2:45 pm
Location: Denmark
Has liked: 62 times
Been liked: 493 times

Re: Benedini Mini and MG flash

Post by Steen Vøler »

Thanks 😀 (again) Adrian
cheers
Steen

www.panzerteam.dk

Post Reply