Machining a Panzer III Cast suspension arm

Forum for discussion relating to the Panzer III/StuG III
Post Reply
Sarah Frazer
Posts: 201
Joined: Sat Oct 17, 2009 8:12 am
Location: Bristol

Machining a Panzer III Cast suspension arm

Post by Sarah Frazer » Wed Aug 22, 2012 2:44 pm

Hi Guys,

Has anyone machined any of Brian Leach's cast Panzer III Suspension arms yet?

I've just had a quick look at one and if you use the standard torsion bar shaft and wheel axle, there is a lot of scale material to remove. I was wondering about making new wheel axles, to reduce the amount of material removed.

Sarah
'I reject your reality and substitute my own'

Post Reply