Jagdpanther no 13

David Brady · Post by **David Brady** » Sun Nov 01, 2020 4:42 pm

Hi,

Some more progress.

: Floor painted

: Cleaning parts - glad this horrible job is over

: Ready for a final sanding 60 grit

Thanks

David Brady · Post by **David Brady** » Fri Dec 18, 2020 11:49 am

Hi,

Some more progress

: Primed and inside painted landrover ivory

: Steve Winstone bumpstops and torsion bar covers fitted

: Covers have been positioned to cover large counter sunk fastener - positions are not strictly by the book, orientation and Qty per side is correct

: To many parts all over the place time to get a few back together

: That's more like it

: Checking the fit

: Handy book

: These steel tracks have done some miles - China to the UK then I sent them to Germany - then back to
the UK when I brought them back off Martin - tracks will be used for static purpose on one of my panther variants

: Should go a nice colour like my king tiger steel tracks

: Mark Lawson Roof vent added

Regards
David

simon_manning · Post by **simon_manning** » Fri Dec 18, 2020 5:07 pm

Nice Extra's and looking good Dave, These were a great model and interesting to build, regards simon.

David Brady · Post by **David Brady** » Sat Dec 19, 2020 3:38 pm

Thanks Simon been looking at yours and Martin's Jagdpanther builds to get some ideas
Cheers

David Brady · Post by **David Brady** » Sat Dec 19, 2020 8:09 pm

Hi,

Nice comparison -

Cheers

David Brady · Post by **David Brady** » Sun Dec 20, 2020 10:09 pm

Hi,

A little more progress

: Filled some combat damage

: Filled a few holes

: Mark Lawson hinges fitted - really nice!

Cheers

David Brady · Post by **David Brady** » Sun Dec 20, 2020 10:54 pm

A few pictures of my sprockets being modified- only one side of the panther sprocket is removable - As I don't have a lathe or the skill to do this I sent them to Steve Winstone - many thanks Steve your help is most appreciated.

: Sprocket after 12 years of running- this will be machined off

: Picture with new steel ring attached -
Steve was only 80% happy as the sprockets would not run true - looks 100% - a true master

Cheers

Chang · Post by **Chang** » Mon Dec 21, 2020 1:50 am

David Brady wrote: ↑
Sun Dec 20, 2020 10:09 pm
.....

1-6 Jagdpanther.jpg (100.18 KiB) Viewed 520 times

Hi David,
Are these two smaller hooks on the engine hatch the genuine Armortek's parts? If yes, what is the part code?
Happy building!

Best regards,
Lerh Chang

David Brady · Post by **David Brady** » Mon Dec 21, 2020 6:08 pm

Hi,

I will check and report tomorrow Chang

Picked up some good quality Secondhand G clamps today - as I never seem to have a large enough clamp.

Cheers

David Brady · Post by **David Brady** » Tue Dec 22, 2020 9:59 pm

Hi,

Rear deck part numbers

: Some more filler - weld will be added

Thanks

Armortek

Jagdpanther no 13

Re: Jagdpanther no 13

Re: Jagdpanther no 13

Re: Jagdpanther no 13

Re: Jagdpanther no 13

Re: Jagdpanther no 13

Re: Jagdpanther no 13

Re: Jagdpanther no 13

Re: Jagdpanther no 13

Re: Jagdpanther no 13

Re: Jagdpanther no 13