Armortek

A question to the suspension

How much shall the end of the suspension arm be in the corresponding opposite hole where the screw goes in from the outside. If the steel rod is pushed all the way in in both ends, it will not be able to reach the hole.

any suggestions/recommentation?

a bit more to share

sanded and polished the casing for the drivesprocket and also made a bit of a casting look on the sprockets themselves. Hard to see, but it will be nice when painted

lower part of the cuppola was also just fittet

thanks Robert Not a lot going on - really busy at work, but managed to install the return rollers and right sprocket case. When doing a dryfit of the sprocket case, the gear was not able to turn as it should. unscrew the case and noticed that the gear itself had a slight oval surface on the side fac...

Mr surfacer is the best. Only downside is the intense smell
Keep the room ventilated

Hi, looking for a Bergepanther

Could be built, unbuilt, partial built as long as it is complete with all parts

Please pm me if you are interested in selling

Welcome to the StuG club Keith

Hi Mick
I do not have any issues with my parts. Everything is aligned perfectly

Nice details Yves

not much to post - am busy at work, but managed to place the order for the motionpack

Hi Adrian
Yes the manual says loctite on the shaft for the bearing

Good looking casemate Yves

Sunday afternoon in the workshop working mainly with the suspension stuff and the main sprocket parts

Loctite was the main stuff used here

Thanks Yves
I believe this will be a fine solution to fix the lover hull without the torsion bar installed

Cheers

Hi Yves
Regarding your roof bolt question - maybe with a bit of luck it can be explained in the Haynes Stug3 book arriving soon in my mailbox

What did you paint hte tracks with by the way?

congratulations and welcome in the StuG 3 build club